Table of Contents
Advertisement
Notice:
Change VLAN settings for every time, you have to reboot the switch to apply new settings.
4.4.3.3 Set flowcontrol
This command allows configuring per port flow control function of GSW-2416SF. The correct usage is shown as below:
Set flo
wcontrol [n] enable/disable
[n]=1-24, n is the specific Port ID.
Enable –
802.3x flow control is enabled on Full-Duplex mode or Backpressure is enabled on Half-Duplex mode.
Disable – No flow
Defa
ult setting: Enable
The configuring per port flow con
EM-GSW2416SFv1
Figure 4-19 VLAN members Configuration screen
control o
r backpressure function on no matter Full-Duplex or Half-Duplex mode.
trol screen in
Figure 4-20
Figure 4-20 Flow Control port Configuration screen
appears.
- 24 -
Hide quick links:
Advertisement
Table of Contents
