Planet GSW-2416SF User Manual page 23

4.4.3.1 Set port [n]
This command allows configuring per port parameters of GSW-2416SF. the correct usage is shown as below:
Set port [n]: n=1-24, to configuring per port parameters of GSW-2416SF.
Default setting: (1) Auto Speed
The configuring per port parameters screen in
Object
(1) Auto Speed
(2) 10 Half
(3) 10 Full
(4) 100 Half
(5) 100 Full
(6) 1000 Full
(7) Disable
4.4.3.2 Set v lan [n]
This command allows configuring up to 24-port based VLAN Groups of GSW-2416SF. The correct usage is shown as
below:
Set vlan [n]: n=1-24, to configuring 24 VLAN Groups of GSW-2416SF. [n] is the VLAN Group ID. And the following
message appears:
Please input port number (1-24), exit press enters: Add/Remove port to the current VLAN Group, "*" means port had
been assign to the VLAN Group.
Default setting: none
The configuring VLAN Groups screen in
EM-GSW2416SFv1
Figure 4-18
Figure 4-18 Port Configuration screen
Description
Setup Auto negotiation of each port.
Force sets 10Mbps/Half-Duplex mode for specific port.
Force sets 10Mbps/Full-Duplex mode for specific port.
Force sets 100Mbps/Half-Duplex mode for specific port.
Force sets 100Mbps/Full-Duplex mode for specific port.
Force sets 10000Mbps/Full-Duplex mode for specific port.
Disable or Shutdown the specific port
Table 4-2 Descriptions of the Port Confi
Figure 4-19 appears. (Assign port 1, port 6 and port 7 to VLAN Group 1)
appears and the detail description shown in table 4-2.
guration screen Objects
- 23 -