Control Head Mechanical Installation; Figure 8-8: Standard U-Shaped Control Head Mounting Bracket (Kit Part Number Kt-008608); Figure 8-9: Optional Control Head Mounting Pedestal (Part Number Macdos0012) - Harris M7300 Installation And Product Safety Manual

8.3.2

Control Head Mechanical Installation

8.3.2.1 Selecting the Mounting Location
When selecting a location for the CH-721 control head, first observe the safety and operator-convenience
related information presented in Section 5.1 on page 26. Always consider and include clearance for the
microphone's connector that must mate to the mic connector on the front panel of the head, and clearance
for the connectors/cables that must mate to the connectors on the rear panel of the head. The CH-721
control head can be mounted under or on top of a mounting surface (typically the vehicle's dash) as space
permits using either the standard U-shaped mounting bracket or the optional mounting pedestal.

Figure 8-8: Standard U-Shaped Control Head Mounting Bracket (Kit Part Number KT-008608)

For a "hanging" control head
installation, the pedestal can
be attached to the top of the
head via threaded holes in
the top of the head's case.
This figure shows
pedestal attached to
bottom of the control head via
threaded holes in the bottom
of the case.
#8-32 Pan-Head Screw; 4
places (Included with
Mounting Pedestal)

Figure 8-9: Optional Control Head Mounting Pedestal (Part Number MACDOS0012)

Socket-Head Cap (Allen) Screw, Lockwasher and Flat
Washer; 2 places each side (Included with kit)
the
the
MM-014763-001, Rev. E
Mounting Bracket (Shown
positioned above control head)
Bracket shown
attached to a CH-721
System model
control head (Head is
not included with
Mounting Bracket Kit)
Pedestal shown
attached to a CH-721
Scan model control
head (Head is not
included with Mounting
Pedestal.)
Control Head Mounting
Pedestal MACDOS0012
(Pedestal can be attached to the
bottom of the head (as shown) or it
can be attached to the top of the
head.)
57