Harris M7300 Installation And Product Safety Manual page 50

MM-014763-001, Rev. E
5. Cut the black wire to the required length plus some additional length for a service loop, then strip
insulation back approximately ¼-inch.
6. Crimp a ⅜-inch non-insulated ring terminal (supplied with the cable) to the end of the black wire.
7. Attach the ring terminal and black wire to the bare metal surface using stainless-steel self-locking
hardware (i.e., machine screws with washers and locking nuts) or other appropriate hardware to
ensure a reliable terminal-to-metal contact. Tighten securely.
8. Apply an approved paint or rust-inhibitor over the remaining exposed bare metal surface and around
the ring terminal.
8.2.2.2 Red Wire and Main Fuse Holder Connection (Radio's Main Power Wire)
1. Continue installation of the radio's DC Power Cable by routing its 20-foot 10-AWG red wire to the
location of the vehicle's battery (or its main DC bus bar or stud). Remove interior panels, door kick
panels, etc., and route the wire through existing channels in the vehicle body as necessary. Protect the
wire from possible chafing where necessary. Tie and stow the wire as necessary.
CAUTION
CAUTION
2. Obtain one of the waterproof (HFB type) fuse holders included with the DC Power Cable.
3. Observe and follow the previously presented WARNING!
4. Cut the red wire to the required length for connection to the battery's positive (+) battery terminal (or
the main DC bus bar or stud).
5. Prepare to splice the waterproof fuse holder into the red wire by cutting it again, at approximately
three (3) to six (6) inches from the end.
50
Plan the routing of the 10-AWG red wire carefully, using an existing access hole in the
vehicle's firewall if possible. Alternately, drill a new hole approximately ⅜-inch in
diameter and install a small rubber grommet to protect the wire from chafing on the
hole's sharp metal edge. To prevent fumes from entering the passenger
compartment, this hole/grommet/wire combination must also be sealed with a
silicon-based sealer before completing the installation.
Do not install any wiring or fuse holder over or in the near vicinity of the vehicle's
engine. Excessive engine heat can cause permanent damage to these components and
can lead to intermittent electrical connection to the battery.
Before making connections to the battery's positive post, carefully disconnect the
battery's negative (ground) cable(s). This will prevent tools or other metallic
objects which come in contact with the battery's positive terminal from shorting to
vehicle ground, causing sparks or even a fire or an explosion! When disconnecting
the negative cable(s), cover/insulate the positive post(s) if it is not already so a tool
cannot short between the posts. Some vehicles, such as those with diesel engines
have more than one battery; in this case, disconnect the negative cables at all
batteries.
Radio and control head fuses should not be installed until all wiring is complete.
This will prevent the radio from powering up prematurely and/or causing an in-
rush of current that could lead to shorting of the battery, sparks, or even fire.