Harris M7300 Installation And Product Safety Manual page 33

A combination ("combo") antenna kit includes a GPS antenna built into the base of the
mobile antenna. Refer to Table 4-5 (page 23) and/or Figure 6-1 (page 31) for available
combo antennas.
1. Once the mounting location is selected, refer to the antenna manufacturer's mounting and testing
instructions for installation guidance. Install the antenna in accordance with these instructions. If
necessary, contact the Technical Assistance Center. See page 20 for TAC contact information. Do not
alter the GPS antenna cable length; tie and stow excess cable as necessary.
2. Route the cable from the antenna base to the location of where the radio will be installed. Remove
headliner panel, interior panels, etc., as necessary. The cable must be kept out of casual contact from
persons within the vehicle. Tie and stow it as necessary to protect it from possible chafing.
3. The antenna cable is connected to the radio's SMA receptacle-type (female) RF connector per a
procedure presented later in this manual. The cable and its (male) SMA connector must be protected
from damage, dirt, and/or metal shavings which may be generated during the mechanical and
electrical installation of the radio. Temporarily tying the connector and cable-end within a small
plastic bag is recommended.
MM-014763-001, Rev. E
33