I/O Device Configuration Window - Contec IPC Series User Manual

4. BIOS Setup

I/O Device Configuration Window

Advanced
Serial Port A :
Base I/O address :
Interrupt :
Serial port B :
Base I/O address :
Interrupt :
Serial port C :
Base I/O address :
Interrupt :
Serial port D :
Base I/O address :
Interrupt :
Parallel port :
Mode :
Base I/O address :
Interrupt :
DMA channel :
Floppy disk controller :
F1 Help
Esc Exit
Figure 4.5. I/O Device Configuration Window (Factory
Serial port A
Serial port B
Serial port C
Serial port D
Parallel port
38
PhoenixBIOS Setup Utility
I/O Device Configuration
[Enabled]
[3F8]
[IRQ 4]
[Enabled]
[2F8]
[IRQ 3]
[Enabled]
[3F8]
[IRQ 5]
[Enabled]
[2E8]
[IRQ 11]
[Enabled]
[ECP]
[378]
[IRQ7]
[DMA3]
[Enabled]
↓ Select Item
←→ Select Menu
Settings)
-/+ Change Values
Enter Select Sub-Menu
: This setting is for SERIAL1 on the
equipment connector plane.
: This setting is for SERIAL2 on the
equipment connector plane.
: This setting is for serial communication
of the touch panel.
: This setting is for RS-422/485 in the
RAS connector on the equipment
connector plane or for SERIAL4 on the
equipment connector plane.
: This setting is for PRINTER on the
equipment connector plane.
Item Specific Help
Configure port
using options:
[Disabled]
No configuration
[Enabled]
User configuration
F9 Setup Defaults
F10 Save and Exit
User's Manual