Planar E2c Display User Manual page 25

Connector Ports
The video signal connector is a standard DVI connector, driving data
to the display. Diagnosis requiring DICOM calibration with the
Dome CXtra software can only be supported on the DVI-D interface.
The Dome E2c display use an 8-pin DIN connector. The power input is
12V ±5% (120 W). See below for details of the DIN connector.
Input power port on connector plate
VCC 8
VCC 7
VCC 6
VCC 5
Assignments on 8-pin DIN connector
1 GND
2 GND
3 GND
4 GND
Connector Ports | 15