Table of Contents
Advertisement
SUPERSERVER 8047R-7JRFT USER'S MANUAL
SATA Subsystem
The SC848 supports up to twenty-four (24) 3.5" hot-swap SAS/SATA drives. These
drives are hot-swappable units and are connected to a backplane that provides
power and control.
Note: The operating system you use must have RAID support to enable the hot-
swap capability of the drives.
Front Control Panel
The SC848E16-R1K62B chassis includes a front control panel on the chassis which
controls the system. This control panel on the SuperServer 8047R-7JRFT provides
you with system monitoring and control. LEDs indicate system power, HDD activity,
network activity, system overheat and power supply failure. A main power button
and a system reset button are also included.
I/O Ports
The SC848 is a proprietary form factor chassis designed to be used in a 4U
rackmount confi guration. The SC848 chassis provides eight full-height, full-length
expansion card slots, a COM port, a VGA port, four USB 2.0 ports, one IPMI Ethernet
port and two 10-gigabit Ethernet ports.
Cooling System
The SC848 chassis accepts four 9-cm and two 8-cm system fans powered from
the chassis and controlled through the IPMI system.
Air Shrouds
The SC848 chassis includes one mylar air shroud that directs the airfl ow where
cooling is needed on the serverboard. Always use the air shroud included with the
system.
Mounting Rails
The SC848 includes a set of quick-release rails, and can be placed in a rack for
secure storage and use. To setup your rack, follow the step-by-step instructions
included in this manual.
1-4
Advertisement
Table of Contents
