Uconnect 6.5 NAV Owner's Manual page 98

NOTE: The Uconnect Phone compatible phones in the
market today do not support rejecting an incoming call
when another call is in progress. Therefore, the user can
only answer an incoming call or ignore it.
Making A Second Call While Current Call Is In
Progress
You can place a call on hold by pressing the "Hold" button
on the Phone main screen, then dial a number from the
dialpad, recent calls, SMS Inbox or from the phonebooks.
To go back to the first call, refer to "Toggling Between
Calls" in this section. To combine two calls, refer to "Join
Calls" in this section.
Place/Retrieve A Call From Hold
During an active call, press the "Hold" button on the
Phone main screen.
Toggling Between Calls
If two calls are in progress (one active and one on hold),
press the "Swap" button on the Phone main screen. Only
one call can be placed on hold at a time.
You can also push the Phone
the active and held phone call.
button to toggle between
Join Calls
When two calls are in progress (one active and one on
hold), press the "Join Calls" button on the Phone main
screen to combine all calls into a Conference Call.
Call Termination
To end a call in progress, momentarily push the Phone
button or press the "end" button on the touchscreen.
Only the active call(s) will be terminated and if there is
a call on hold, it will become the new active call.
Redial
Press the "Redial" button on the touchscreen, or push the
Phone button and after the "Listening" prompt and
the following beep, say "Redial."
The Uconnect Phone will call the last number that was
dialed from your mobile phone.
Call Continuation
Call continuation is the progression of a phone call on the
Uconnect Phone after the vehicle ignition has been
switched to OFF.
UCONNECT PHONE 97
6