DO NOT
exert excessive side forces on platform while elevated.
DO NOT
overload, the lift relief valve does not protect against overloading when the platform is elevated.
DO NOT
alter or disable limit switches or other safety devices.
DO NOT
exceed the rated capacity of your scissorlift and make sure the load is evenly distributed on the
platform.
DO NOT
raise your platform in windy or gusty conditions.
DO NOT
operate on surfaces not capable of holding weight of the work platform including the rated
load, e.g. covers, drains, and trenches.
BE AWARE
of overhead obstacles, and poorly lit areas in case of overhaed obstacles.
DO NOT
elevate the work platform if it is not on firm level surfaces. Avoid pot holes, loading docks,
debris, drop offs and sufaces that may affect the stability of your work platform.
DO NOT
climb or descend a grade steeper than 20% (SJIII Compacts), or 25% (SJIII Conventionals).
Elevated driving must only be done on firm level surfaces. (Ref. Table 1-1)
ENSURE
that there is no person(s) in the path of travel.
An Operator Should Not Use Any Work Platform That:
Has ladders, scaffolding or other devices mounted on it to increase its size or work height.
Does not have a clean, uncluttered work area.
Does not appear to be working properly.
Has been damaged or appears to have worn or missing parts.
Has alterations or modifications not approved by the manufacturer.
Has safety devices which have been altered or disabled.
SJIII Series - The CONVENTIONALS
WARNING
JOBSITE HAZARDS
WARNING
WORK PLATFORM CONDITIONS
Complete Revision 99-05-01
SECTION 1, Page 3