Advanced Formatting - Pepperl+Fuchs PSCAN-D-1D-D2 Installation And Operation Manual

PSCAN-D-1D-D2 Division 2 Barcode Reader
Enter Configuration
Ì$+;Î

Advanced formatting

•
Concatenation
SELECT EAN/UPC PREFIXES
•
Advanced formatting
When scanning the following codes, barcodes starting with the selected
prefixes will be read and transmitted only if the ADD ON is present. If no ADD
ON is found, the barcode will not be read. Barcodes starting with different
Please follow the setup procedure carefully for these
characters are read regardless of ADD ON presence and transmitted always
parameters
NOTE without ADD ON.
Enter Configuration
Ì$+;Î
select one or more of the following prefixes:
434/439
ÌET3434ET4439ÉÎ
Permits the concatenation of two codes defined by code type and length. It is possible to set a
timeout for the second code reading and to define code transmission if the timeout expires.
977
ÌET7977QÎ
The order of transmission is CODE 1-CODE 2.
1
979
ÌET9979cÎ

The commands above are not mutually exclusive. They can be used to configure more than one
set of prefixes simultaneously.

Subject to modifications
52
USA: +1 330 486 0002
CODE SELECTION
 Cancel All Selections
ÌET0wÎ
ADVANCED FORMATTING
OR
CONCATENATION
ÌET1378ET2379PÎ
ÌEI0aÎ
ÌEI1dÎ
ÌET5414ET6419}Î
Define Concatenation
ÌET8978ZÎ
ÌEK0eÎ
Read the code type from the Code Identifier Table beginning in Appendix
ÌEL0gÎ
Read a number in the range 01-99 from the Hex/Numeric Table.
www.pepperl-fuchs.us
Germany: +49 621 776 2222
Exit and Save Configuration
Ì$-?Î
1. Read the Enter Configuration code ONCE.
2. Read configuration codes from the desired groups.
•
Read the code and follow the procedure given
Default value
u
3. Read the Exit and Save Configuration code ONCE.
Exit and Save Configuration
378/379
 disable
enable
414/419
978
Code 1
code ID
, page 75.
code length
97
Copyright Pepperl+Fuchs
Singapore: +65 6779 9091
Ì$-?Î
B
.
111