Rs232 Parameters - Pepperl+Fuchs PSCAN-D-1D-D2 Installation And Operation Manual

PSCAN-D-1D-D2 Division 2 Barcode Reader

RS232 parameters

•
Baud rate
•
Parity
•
Data bits
•
Stop bits
•
Handshaking
•
Ack/nack protocol
•
FIFO
•
Inter-character delay
•
Rx timeout
•
Serial trigger lock
1. Read the Enter Configuration code ONCE.
2. Read configuration codes from the desired groups.
•
Read the code and follow the procedure given
Default value
u
3. Read the Exit and Save Configuration code ONCE.
Restore PSCAN-D default
Default serial interface
Parameter
Baud rate
Parity
Data bits
Stop bits
Handshaking
ACK/NAK protocol
FIFO
Inter-character delay
Rx timeout
Serial trigger lock
Default data format
Subject to modifications
USA: +1 330 486 0002 Germany: +49 621 776 2222
Default
9600
Disabled
8
1
Disabled
Disabled
Enabled
Disabled
5 seconds
Disabled
www.pepperl-fuchs.us Copyright Pepperl+Fuchs
Singapore: +65 6779 9091
Parameter
Code identifier
Custom code identifier
Header
Terminator
Field adjustment
Field adjustment character
Code length Tx
Character replacement
Default power save
Parameter
Sleep state
Enter sleep timeout
Default reading parameter
Parameter
Trigger type
Trigger signal
Trigger click
Trigger-off timeout
Flash mode
Reads per cycle
Safety time
Beeper intensity
Beeper tone
Beeper type
Beeper length
Default
Disabled
Disabled
No
No
Disabled
Disabled
Not transmitted
Disabled
Default
Disable
0.6 seconds
Default
Hardware trigger
Trigger active level
Disabled
Disabled
On 1 second, off 0.6 seconds
1
0.5 seconds
High intensity
Tone 2
Monotone
Short
9