Table of Contents
Advertisement
PSCAN-D-1D-D2 Division 2 Barcode Reader
Laser safety compliance
The barcode reader conforms to the following applicable requirements at
the date of manufacture:
•
EN 60825-1
•
CDRH 21 CFR 1040
The laser light is visible to the human eye and is emitted from the output
window.
Warning! Laser Light
•
The human eye can be damaged.
•
Do not stare into beam of the laser light.
•
Any changes to the device are forbidden. These
could cause a dangerous laser light.
Warning
•
Please consider the procedures described in these
operating instructions.
•
Prevent the laser beam from hitting reflective
surfaces such as mirrors, etc.
A warning label is attached to the barcode reader describing the laser
and laser category. The device is a class 2 laser. It is not necessary to
open the barcode reader for installation, application, or maintenance.
Labels cannot be attached to a laser diode. Hence, the respective values
are listed below:
Laser Class 2M
EN 60825-1
Maximum Output
Wavelength according to Class 2 N-60825-1
and CDRH21CFR 1040
Repair and maintenance
The devices must not be repaired, changed, or manipulated. If there is a
defect, the product must always be replaced with an original device.
Applied standards and guidelines
Electromagnetic compatibility
Low voltage
Explosion protection
Subject to modifications
2
USA: +1 330 486 0002
0.9 mW
630-690 nm
NE 21
ANSI/UL 60950-1-2007
ANSI/ISA-12.12.01-2007; CSA
C22.2 No. 213-M1987, R2008
www.pepperl-fuchs.us
Germany: +49 621 776 2222
Product specifications
PSCAN-D-1D-D2 function
The PSCAN-D-1D-D2EX barcode reader can be used in Class I/Div. 2 and
Class II/Div. 2 hazardous areas. The barcode reader is able to read all
standard 1-D code families. After a successful read, a beep to indicate
a good read is sent out for easy operation. In addition, a bidirectional
communication is possible. Supply and communication of the barcode
reader is made by a nonincendive interface.
Additional functions include:
Aiming system
First, a partial trigger produces a red spot for easy aiming. By completely
pressing the trigger, a line appears to start code scanning.
GL-technics (3 green lights)
A good read is shown via an audio signal, green LEDs on upside and
underside, plus a green scan line directly on the barcode.
Using PSCAN-D-1D-D2 readers
The PSCAN-D-1* barcode reader automatically scans barcodes up to a
certain distance. See the Reading characteristics chart on page xx. Simply
aim and pull the trigger. Code scanning is performed along the scan line
emitted from the reading window. The line must cross the entire code.
Best reading angles
For good reading performance, do not hold the barcode reader vertically.
Use the reading angles in the figure below.
Device components
OK
OK
OK
OK
•
Barcode reader
•
Connecting cable consisting of a helix cable 3 m and a male 4-pin
connector (M12 connector) mounted.
Copyright Pepperl+Fuchs
Singapore: +65 6779 9091
OK
OK
OK
OK
Advertisement
Table of Contents
