JLG Skytrak 6036 Operation & Safety Manual page 158

Section 7- Lubrication and Maintenance
The rims installed have been designed for stability requirements which consist of track
width, tire pressure and load capacity. Size changes such as rim width, center piece
location, larger or smaller diameter, etc., without written factory recommendations, may
result in unsafe condition regarding stability.
D. Wheel Installation
Torque lug nuts after first 50 hours and after each wheel installation.
Note: If machine is equipped with directional tire assemblies, the wheel and tire assemblies
must be installed with the directional tread pattern "arrows" facing in the direction of forward
travel.
1. Start all nuts by hand to prevent cross threading. DO NOT use a lubricant on threads
or nuts.
2. Tighten lug nuts in an alternating pattern as indicated in figure. See page 9-6 for
torque value.
TIP OVER HAZARD. Lug nuts must be installed and maintained at the proper torque
to prevent loose wheels, broken studs and possible separation of wheel from the axle.
7-24
3 5
1
10
8
4
6
WARNING
7
9
2
OY1220
31211018