JLG Skytrak 6036 Operation & Safety Manual page 155

B. Restriction Fault Code
1. Fault Code 107:15 indicates restricted air filter.
2. Primary element (5) must be replaced.
C. Element Change (as restriction indicator or fault code indicates)
Note: Change elements as air cleaner restriction indicator or restriction fault code indicates or
every two years. Use the interval that occurs first.
1. Perform "Shut-Down Procedure" on page 4-3.
2. Open engine access door.
3. Unlock air cleaner cover (4) and remove from air cleaner.
4. Remove outer primary element (5). Inspect element for damage then discard.
5. Thoroughly clean interior of air cleaner canister and vacuator valve.
6. Replace inner safety element (6) every third primary element change or if primary
element was found to be damaged. If replacing inner safety element at this time,
carefully slide element out and replace with new element.
7. Slide new primary element over inner safety element making sure the sealing edge is
flush with the base of the air cleaner.
8. Position air cleaner cover in place and lock into position.
9. Depress button on restriction indicator to reset.
10. Close and secure engine access door.
Note: Elements should never be washed or reused. Always install new elements.
EQUIPMENT DAMAGE. Primary and safety elements are required to be replaced if
used in an application longer than two years regardless of hours of operation.
31211018
Section 7- Lubrication and Maintenance
NOTICE
7-21