JLG Skytrak 6036 Operation & Safety Manual page 129

Installation Procedure:
• Refer to "Attachment Installation" on page 5-10.
CRUSH HAZARD. Remove large objects in path of sweeper before operating. Failure
to comply could cause object to be thrown by sweeper.
Operation:
• Fully retract boom and lower until all four sweeper wheels are in contact with the
ground.
• Operate auxiliary hydraulic lever to engage sweeper brushes.
• Sweep a path less than the width of the sweeper.
• Travel in accordance with requirements set forth in Section 1- General Safety Practices.
• To empty hopper, raise sweeper over desired dump area ensuring proper clearance.
Operate auxiliary hydraulic lever to open the hopper allowing the contents to slide
out. Close the hopper after all contents are removed.
Equipment Damage Precautions
• Except for emptying hopper, the boom must be fully retracted for all sweeper
operations.
• Avoid excessive downward pressure on brushes when sweeping.
• Do not store sweeper with weight on brushes. Place on blocks or storage stands.
31211018
WARNING
Section 5- Attachments
5-49