Table of Contents
Advertisement
ROAMEO System
Antenna connection and placement
Antennas should be in the upright-most position for the best reception of signal. The antenna has a joint to adjust the angle, if
needed.
To attach the antennas to the ROAMEO AP-1800, do the following:
Gently push the antenna into the antenna connector on the ROAMEO AP-1800. Take care to align the connector
1.
pin with the antenna pin hole.
Turn the antenna clockwise to tighten in place.
2.
NOTE: For permanent antenna installation, we recommend tightening the antennas so they cannot come loose from
vibration or if bumped. Hand-tighten the antenna, then using needle-nose pliers, grasp the serrated metal
collar of the antenna and tighten about 1/16th inch (1.6 mm) more in the clockwise direction. This tightens
the connector to about 5 lbf-in (0.56 Nm), the specification for a solid connection.
Bosch Security Systems, Inc.
Technical Manual
Installation 51
F.01U.306.750
Rev. 01
Advertisement
Table of Contents
