Viewing Stopwatch Data; Setting The Alarm; Adjusting Hand And Day Indicator Alignment; Phone Finder - Casio 5512 Operation Manual

Viewing Stopwatch Data

This section explains how to send lap times
and split times (up to 100 records) stored in
watch memory, and other data to your phone
for viewing with CASIO WATCH+.
Sending Stopwatch Data to a Phone
●
Use the procedure below to send data from
the watch to a phone.
1.
Y Tap the "CASIO WATCH+" icon.
2.
X Hold down the (C) button for about 2
seconds.
This causes the second hand to move
●
to 12 o'clock. Keep (C) depressed at
this time until the second hand
completes one full rotation.
The retrograde dial hand will move from
●
"R" to e when a connection is
established between the watch and
phone.
3.
Y Perform the operation shown on the
phone screen to transfer data measured
by the watch to the phone.
After data transfer is complete, a list of the
measurement data will appear on the
phone display.
Tapping a stopwatch data item displays
●
its details.
Checking a Lap Time
●
Use CASIO WATCH+ to check the data you
sent to the phone.
1.
Y Tap the "CASIO WATCH+" icon.
2.
Y Perform the operation shown on the
phone screen to view the measurement
data you want.
Note
Tapping "Edit" displays a screen that
●
you can use to change the data item
title and to delete lap time data.
Operation Guide 5512

Setting the Alarm

1.
Y Tap the "CASIO WATCH+" icon.
2.
X Hold down the (C) button for about 2
seconds.
This causes the second hand to move
●
to 12 o'clock. Keep (C) depressed at
this time until the second hand
completes one full rotation.
The retrograde dial hand will move from
●
"R" to e when a connection is
established between the watch and
phone.
3.
Y Perform the operation shown on the
phone screen to configure alarm time
settings.
Adjusting Hand and Day
Indicator Alignment
If the hands and/or date indicator are out of
alignment even though auto time adjustment
is being performed, use CASIO WATCH+ to
adjust them.
1.
Y Tap the "CASIO WATCH+" icon.
2.
X Hold down the (C) button for about 2
seconds.
This causes the second hand to move
●
to 12 o'clock. Keep (C) depressed at
this time until the second hand
completes one full rotation.
The retrograde dial hand will move from
●
"R" to e when a connection is
established between the watch and
phone.
3.
Y Perform the operation shown on the
phone screen to correct hand alignment.

Phone Finder

You can use phone finder to trigger a tone on
the phone to make it easy to find. The tone is
forced to sound even if the phone is in the
manner mode.
Important!
Do not use this function in areas
●
where phone call tones are
restricted.
The tone sounds at a high volume.
●
Do not use this function when
listening to phone output over
earphones.
1.
X If the watch is connected with a phone,
press any button to terminate the
connection.
Connected After disconnection
2.
X Hold down the (A) button for about 2
seconds.
This will cause the watch to enter the
Calendar Mode.
3.
X Hold down the (D) button for about 1.5
seconds until the second hand points to
"R".
The retrograde dial hand will move to e
when a connection is established
between the watch and phone, and then
the phone will sound a tone.
It will take a few seconds before the
●
phone tone sounds.
4.
X Press any button to stop the tone.
You can press any watch button to stop
●
the phone tone only during the first 30
seconds after it starts to sound.
8