Configuring Dual Time Settings; Swapping Your Current Location Time And Dual Time Settings; Stopwatch; Split Times And Lap Times - Casio 5512 Operation Manual

Configuring Dual Time
Settings
Dual Time lets you keep track of the current
time in another time zone in addition your
current location time.
Dual Time 24-hour
Dual Time
1. Pull out the crown to the first click.
This causes the second hand to move to
12 o'clock.
2. Rotate the crown to change the Dual Time
setting.
You can set the Dual Time in 15-minute
●
increments.
Dual Time 24-hour hand
Dual Time minute hand
Dual Time hour hand
3. Push the crown back in.
Swapping Your Current
Location Time and Dual Time
Settings
You can swap the time in your current location
with the Dual Time by holding down (B) for
about three seconds.
Before swapping After swapping
Current location time Dual Time
Dual Time Current location time
Note
If you are using the small hour and
●
minute hands for Dual Time, only the
time in your current location will be
swapped with Dual Time. Dates are
not swapped.
Operation Guide 5512
The stopwatch can measure elapsed time up
to 23 hours, 59 minutes, 59.95 seconds.
In addition to normal elapsed time
measurements, the stopwatch also lets you
take lap time readings. You can also specify a
target value and have the watch indicate the
difference between a lap time reading and the
target value (lap time).
Checking the Difference between a Lap
l
Time and the Target Time
Note
If an ongoing elapsed time
●
measurement operation continues
for 24 hours, the measurement will
stop and the stopwatch will reset to
all zeros automatically.
Getting ready
Perform this procedure in the Stopwatch
Mode.
Navigating Between Modes
l
＋
−
Crown

Split Times and Lap Times

Split time
●
A split time is the time elapsed from the start,
up to any point along the course of an event.
You can use the operation shown below to
take split time readings.

Stopwatch

Stopwatch Mode
B
Start
Split 1
D
Split 2
D
Split 3
B
Goal
Lap time
●
A lap time shows the time elapsed during a
specific lap. As with split times, the watch
continues performing elapsed time
measurement internally while a lap time or
split time reading is indicated. The watch
calculates and indicates the difference
between a lap time reading and the target
value.
B
Start
Lap 1
D
Lap 2
D
Lap 3
B
Goal
Note
Lap times can be viewed with CASIO
●
WATCH+ after measurement is
complete.
Viewing Stopwatch Data
l

Measuring Elapsed Time

1/20 (0.05) second
Lap evaluation
Seconds
Minutes
Hours
1.
Use the operations below to measure
elapsed time.
The retrograde dial acts as a second
●
hand for about 30 seconds after a time
measurement operation is started.
B
Start
B
Stop
B
Resume
B
Stop
2.
Press (D) to reset the elapsed time to all
zeroes.
3.
Press (A) twice to return to the Calendar
Mode.
24-hour
12