Calibrating Depth Stop; V-Belts - Grizzly G0823 Owner's Manual

Calibrating Depth
Stop
Depth stop accuracy may be improved by calibrat-
ing the depth stop. See Figure 44 for depth stop
components. Make sure the spindle is retracted
all the way into the quill, then follow the steps
below.
To ensure accuracy over time, re-check "0" of
depth stop periodically.
Note: The depth stop scale functions as a general
guide only. It is not intended for high-tolerance,
precision results. See Accessories on Page 28
for precision depth indicator options.
Tool Needed
Hex Wrench 2.5mm ........................................... 1
Depth Stop
Indicator
Depth Stop
Scale
Adjustment
Dial
Figure 44. Depth stop components.
To calibrate depth stop:
1. Rotate depth stop adjustment knob to lower
depth stop (see Figure 45) until indicator
plate reaches bottom of its travel.
-36-
Note: Indicator plate may extend below "0"
hash mark when it reaches bottom of travel.
Indicator
Plate
Figure 45. Depth stop set at "0" for calibration.
2. Loosen cap screw shown in Figure 45, and
position indicator plate so upper edge of plate
Qty
aligns with "0" on the scale, then re-tighten
cap screw to secure setting.
Inspect regularly for tension and wear. Refer to
Figure 46 for proper belt tension. Belt deflec-
tion should be approximately
pressure. Replacement V-belts can be found in
the back of this manual in the part breakdowns.
Check pulleys to ensure that they are properly
aligned when installing V-belts.
To replace the V-belts, refer to Changing Spindle
Speed on Page 22 to loosen the belts. Remove
them from the pulleys, then install new V-belts.
Deflection
Figure 46. Inspecting belt tension.
Cap
Screw

V-Belts

⁄ " under moderate
1
4
Pulley
⁄ "
1
4
Pulley
Model G0823 (Mfd. Since 2/16)