Grizzly G0823 Owner's Manual page 34

Quill & Column Surfaces
Oil Type ......Model T23962 or ISO 68 Equivalent
Oil Amount ............................................Thin Coat
Lubrication Frequency ...........8 Hrs. of Operation
Use the controls to access the entire smooth
surfaces of the quill and column (see Figures
39–40), then clean them with mineral spirits and
shop rags.
Note: Avoid removing the grease from the column
racks during cleaning.
Figure 39. Quill surface location.
Figure 40. Column surface locations.
When dry, apply a thin coat of oil to the surfaces.
Move the components through the entire path of
travel to distribute the lubricant.
-32-
Column Rack, Quill Rack & Pinion
Grease Type ......... NLGI#2 Grease or Equivalent
Grease Amount ....................................Thin Coat
Lubrication Frequency ......... 90 hrs. of Operation
Move the quill up and down to gain full access to
the quill rack & pinion (see Figure 41), then clean
the teeth with mineral spirits, shop rags, and a
brush.
Next, clean the column rack teeth with mineral
spirits, shop rags, and a brush.
Quill
Surface
When dry, use a brush to apply a thin coat of
grease to the teeth, then raise/lower the quill to
distribute the grease.
Note: Re-apply oil to the quill smooth outside
surface that was removed during the cleaning
process.
Column
Surfaces
Pinion
Figure 41. Quill rack & pinion locations.
Model G0823 (Mfd. Since 2/16)
Quill
Rack
Column
Rack