Setting Outfeed Table Height; Calibrating Depth Scale - Grizzly G0586 Instruction Manual

Setting Outfeed
Table Height
The outfeed table must be level with the knives
when they are at top-dead-center.
To set the outfeed table height:
1. Place a straightedge on the outfeed table so it
extends over the cutterhead.
2. Rotate the cutterhead pulley until one of the
knives is at top-dead-center (TDC), as illus-
trated in Figure 44.
��������
������
Figure 44. Cutterhead knife at top-dead-center.
3. Raise or lower the outfeed table until the knife
just touches the straightedge (Figure 45).
������������
�������
Figure 45. Using a straightedge to align outfeed
table height with knife at TDC.
4.
Lock the outfeed table.
G0586 8" X 75" Deluxe Jointer
The depth scale on the infeed table can be cali-
brated or "zeroed" if it is not correct.
To calibrate the depth scale:
1.
Set the outfeed table height as described in
the Outfeed Table Height sub-section.
2. Place a straightedge across the infeed and
outfeed tables.
3.
Adjust the infeed table until it is level with the
outfeed table, as illustrated in Figure 46.
������
Figure 47. Depth-of-cut pointer
adjusted to "0" position.
-31-