Grizzly G0823 Owner's Manual page 20

The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, and 2)
the emergency stop button works correctly.
Refer to Figures 13–14 for the locations of the
various controls necessary for performing the
Test Run.
Forward
Button
Power
Indicator
Light
Stop
Button
Figure 13. Location of controls necessary for
Test Run.
To test run machine:
1. Clear all setup tools away from machine.
2. Connect machine to power supply.
3.
Rotate E-STOP button clockwise. Button
should pop outward and power indicator light
should illuminate.
4.
Press FORWARD button on control panel
to turn machine ON. The motor should run
smoothly and without unusual problems or
noises.
5. Press STOP button to turn spindle OFF.
Allow spindle to come to a complete stop.
6. Press REVERSE button to turn spindle ON.
The motor should run smoothly and without
unusual problems or noises in the opposite
direction.
-18-
7.
8.
9.
Reverse
Button
E-Stop
Button
10. WITHOUT resetting Emergency Stop but-
Press STOP button to turn spindle OFF.
Allow spindle to come to a complete stop.
Press FORWARD button on control panel to
turn machine ON.
Press Emergency Stop button to turn machine
OFF.
Figure 14. Resetting the switch.
ton, try to start machine by pressing the
FORWARD button. The machine should not
start.
— If the machine does not start, the safety
feature of the Emergency Stop button is
working correctly. Congratulations! The
Test Run is complete.
— If the machine does start, immediately
turn it OFF and disconnect power. The
safety feature of the Emergency Stop but-
ton is NOT working properly and must be
replaced before further using the machine.
Model G0823 (Mfd. Since 2/16)