Adjusting Headstock; Controlling Table Travel - Grizzly G0836 Owner's Manual

Adjusting Headstock

The headstock can be adjusted up and down the
column (Z-axis). The G0836 has a dovetailed
slide that allows users to reposition the headstock
or change tooling without losing workpiece align-
ment with a hole or milling path.
To raise or lower headstock:
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen Z-axis lock handle shown in
Figure 26.
Figure 26. Z-axis lock handle.
3. Use Z-axis handwheel shown in Figure 27 to
adjust headstock height. Each full turn of the
handwheel moves the headstock 0.05".
Note: For maximum spindle rigidity when
milling, keep the spindle retracted into the
headstock as far as possible with quill locked
and fine downfeed lock knob tightened.
Z-Axis
Handwheel
Figure 27. Z-axis handwheel.
-26-
The table travels in two directions, as illustrated
in Figure 28:
•
•
Z-Axis
Lock Handle
Both the X- and Y-axis feature table locks. To
ensure unexpected movement of the table does
not occur during precision operations, use these
locks to secure the table along any axis that
should not move for any given operation.
The table handwheels have graduated dials in
0.001" increments, with one full revolution equal-
ling 0.10".
Y-axis table travel is adjusted with the handwheel
on the front of the table base (see Figure 29).
Controlling
Table Travel
X-axis (longitudinal, controlled by power
feeder or handwheel)
Y-axis (cross, controlled by handwheel)
Power
Feed
X-Axis or Longitudinal Travel
(Left & Right)
Figure 28. Directions of table movement.
Y-Axis Handwheel
X-Axis
Table Lock
Figure 29. Y-axis table controls.
Model G0836 (Mfd. Since 09/17)
Y-Axis or
Cross Travel
(In & Out)
Y-Axis
Table Lock