Dc-2009 Data Collection Software Setup; Introduction; Setting Up The Sip Server For Packet (Internet) Connections; Starting The Dc-2009 System Configuration - Honeywell CNI2 Operating And Installation Manual

CNI2 Operating and Installation Guide

DC-2009 DATA COLLECTION SOFTWARE SETUP

INTRODUCTION

This chapter introduces the fundamental data collection setup parameters needed to start the
communications process with the CNI2. It does not address reports or database management.
Additional training is available from Honeywell, as well as hands-on training options.

SETTING UP THE SIP SERVER FOR PACKET (INTERNET) CONNECTIONS

For Packet (Internet) connections the SIP server acts as an Internet server on your computer
and thus must be allowed access to the outside world. An Internet address and port number
must be assigned to the SIP server, and these numbers must be programmed into each CNI2.
Your computer systems' administrator usually assigns the address and port number.
Start the DC-2009 Applications Launcher and select "System Configuration".

Starting the DC-2009 System Configuration

On the next screen select the Data Collection process. There may be more than one to choose
from depending upon the way DC-2009 has been configured.
117