Error Codes; Example Of Error Code "35" Display - Honeywell CNI2 Operating And Installation Manual

15 minutes after the unit is powered-up or reset the LEDs will no longer display the call
However if a new call is triggered by the magnetic CALL switch or the TAMPER switch the
The two LEDs on the CNI2 board are used to indicate call progress and call status. They are
also used to display error codes.
In the event of an error the LEDs will be flashed in a pattern that represents a 2-digit number.
The red LED represents the first digit while the
an error code of "35", the
An error code is displayed several times to allow the user to observe the pattern.
Error codes are listed on the next few pages.
The last 30 error codes are saved in the CNI2's memory and are reported to the data collection
system with each call, but only if calling into DC-2009
this information.
15 minutes after the unit is powered-up or reset the LEDs will no longer display error
codes. This is done to conserve power. Errors that do occur will still be logged in memory
However if a new call is triggered by the magnetic CALL switch or the TAMPER switch
then new error codes will be displayed for another 15 minutes.
CNI2 Operating and Installation Guide
progress. This is done to conserve power.
LEDs will be reactivated for another 15 minutes.

ERROR CODES

red LED will flash 3 times and then the

Example of Error Code "35" Display

and reported to the data collection system.
NOTE
green LED the second digit. For instance, for
green
®
or InvisiConnect
NOTE
103
LED will flash 5 times.
® ®
. MV90 will not accept