Meter Index Base; Wall Mount Hangers Assembly Sequence - Honeywell CNI2 Operating And Installation Manual

CNI2 Operating and Installation Guide
Assembly sequence for the backside hangers is shown in the illustration below. The lock-
washer contacts directly with the enclosure, then the hanger, the flat washer, and lastly the
screw to secure. Tighten the screw until snug, but do not over-tighten.

Wall Mount Hangers Assembly Sequence

METER INDEX BASE

Where it is desired to have an index base mounted directly to a meter, the UMB (Universal
Mounting Bracket) option is available. The advantages of this package are that the entire
instrument can be mounted without any concerns about routing external meter pulse signal
wires. Mounting of the UMB index base is possible on rotary, turbine, and diaphragm gas
meters that have a rotating instrument drive output. This includes American, Rockwell, Romet,
Roots, or Schlumberger meters.
The UMB housing may be rotated about the base plate so that the instrument and index will
face in any of the four directions. Remove all four screws which attach the base plate to the
bracket housing. Replace and tighten the four screws after you have repositioned the UMB
housing.
17