Final Assembly - Emerson CF330GRT00 Owner's Manual

6.1
Engage the Fan Motor 2-Pin Wire Connector into the
2-pin Wire Connector of the LED Array (Figure 20).
The connection is complete when you hear a soft click.
6.2
Carefully tuck all the wires and connectors into the Light
Kit Housing Assembly.
Position the LED Array onto the Light Kit Housing
Assembly, aligning the three holes.
NOTE: Verify that the wires and connectors are not
trapped between the LED Array and the Light Kit
Housing Assembly.
Install and tighten the three #6-32 x 1/4" Tress Head
Screws with Lockwashers (Figure 21) for assembly of
the LED Array.
WARNING
!
To avoid possible fire or shock, do not pinch wires
between the Light Kit Housing Assembly and the
LED Array.
6.3
Place the Shade into the opening of the Light Kit
Housing Assembly, aligning the three flat areas on the
top edge of the Shade with the three raised dimples on
the Light Kit Housing Assembly and turn the Shade
clockwise until it stops (Figure 22).
NOTE: Periodically check that the shade is seated
fully clockwise in the Light Kit Housing Assembly.

6. Final Assembly

FAN MOTOR
2-PIN WIRE CONNECTOR
LED ARRAY
2-PIN WIRE CONNECTOR
LED ARRAY
Figure 20
LED ARRAY
LIGHT KIT HOUSING
ASSEMBLY
Figure 21
Figure 22
14
#6-32 x 1/4" TRESS
HEAD SCREWS WITH
LOCKWASHERS (3)
SHADE FLAT
AREA (3)
ROTATE
CLOCKWISE SHADE
LIGHT KIT
HOUSING
ASSEMBLY
DIMPLES (3)