Table of Contents
Advertisement
MX8x8HDMI-Pro series
User's manual
Step 9. Upgrade firmware(s).
Click Upgrade selected firmwares button. A confirmation message appears. After clicking
the Yes button the selected controllers are being reprogrammed, with the firmware you
selected. If you select a file that does not fit for the selected controller, you will get an
information message about which file is wrong. If you selected a controller to upgrade, but
you had not selected a file for it, then you will also get an information message about which
file is missing.
Quick Bootload mode can be switched on or off any time. It makes the bootloader software
faster by only checking the checksum of the controller. No data verification is done after
writing if the checksum was correct.
ATTENTION!
The reprogramming can take between 3-8 minutes per controller.
A progress bar will show the current state of the reprogramming. With some controller type
an erasing process will take place first, and then the programming is done, so the progress
bar runs up twice.
When the reprogramming is finished, a Done! message will appear in the bottom left corner.
The application closes the connection, and the router restarts.
Step 10. Done!
If the upgrade was successful, the following window pops up:
Now you can close the application, or you can select another matrix router to upgrade. After
closing the bootloader application, switch the upgraded devices off and then on. Now the
router is ready to be used with the new firmware!
Chapter 8. Firmware upgrade
Page 75 / 81
Advertisement
Table of Contents
