WisyCom MTP40S-US User Manual page 9

The following table sums up which parameters can be set and the related range settings.
PARAM
MENU
ETER
CH
GR
TUNING
Freq
AF In Gain
Phase
AUDIO HP Filt.
Noise R.
Limiter
RF Power
RF/BATTERY
Battery
Led Light
LED
Led Mode
Mode
MIC
PTT Mode
MTP40S-US/USX User Manual
Device is forced in bootloader mode to allow FIRMWARE UPDATE.
MEANING RANGE SETTINGS
Channel 0 ÷ 59
Group 0 ÷ 39 + SYNC GROUP
depends on the MTP40S Model:
Frequency
Gain of the audio depends on the mic mode setting
signal
Audio signal phase 0° or 180°
High Pass filter Flat/60/80/120/170/250/400 Hz
ENR: Wisycom Extended-NR,noise optimized
Noise reduction
ENC: Wisycom Extended-NC,voice optimized
Limiter On/Off
RF Power 10mW or 50mW or 100mW(only USX option)
Battery type Alkaline or NiMH
Power switch green
0 ÷ 16
brightness
It defines when the
None: never
power switch led
ModPeak: when audio get close to saturation
(see Fig. 3) has to
PTT: when the PTT button is pushed
become RED
'2 wires'
'2 wires + bias'
MIC type '3 wires'
'2 wires & phantom'
'2 wires + bias & phantom'
Disable:when the PTT button is pushed, nothing
happen. (the transmitter sends AF+Tone squelch)
Normal: when the PTT button is pushed, the
It defines how and transmitter send a different RF signal. According to the
what information receiver configuration the audio can be
the transmitter has enabled/disable on LINE (and/or COM).
to send Muting: the transmitter doesn't send the audio. The
voice is cut, it doesn't enter to the microphone
No Data: the transmitter sends neither tone squelch
nor battery data.
1 470-640
2 566-798
3 510-698
(ex. -40dB ÷ 40dB step of 1 dB)
Rev.01
9