Switching The Dimmer Setting; Selecting The Brightness; Setting The Rear Output And Subwoofer Controller - Pioneer Super Tuner III DVH-P7050 Owner's Manual

Initial Settings
on or off with E or e.
2 Select
AUX
Pressing E or e will switch
and off and that status will be displayed (e.g.,
).
AUX :ON
• Pressing 5 or ∞ on the head unit also per-
forms the same operation.

Switching the dimmer setting

To prevent the display from being too bright at
night, the display is automatically dimmed
when the car's headlights are turned on. You
can switch dimmer on or off.
1 Press to select
F DIM
Press repeatedly until
F
display.
• Pressing
FUNCTION
performs the same operation.
on or off with E or e.
2 Select
DIM
Pressing E or e will switch
on and off and that status will be displayed (e.g.,
).
Dimmer :ON
• Pressing 5 or ∞ on the head unit also per-
forms the same operation.

Selecting the brightness

You can select the display brightness. Initially
this mode is set to 12.
1 Press to select
F BRIGHT
Press repeatedly until
F
the display.
• Pressing
FUNCTION
performs the same operation.
between on
AUX
.
appears in the
Dimmer
on the head unit also
between
Dimmer
.
appears in
Brightness
on the head unit also
2 Select the desired brightness with
E or e.
• The display shows –
0
• Pressing 5 or ∞ on the head unit also per-
forms the same operation.
Setting the rear output and sub-
woofer controller
This unit's rear output (rear speaker leads out-
put) can be used for full-range speaker (
) or subwoofer (
SP:FULL
tion. If you switch rear output setting to the
, you can connect a rear speaker lead
SP:S.W
directly to a subwoofer without using an auxil-
iary amp.
Initially, the unit is set for rear full-range speaker
connection (
Rear SP:FULL
When rear output are connected to full range
speakers (when
Rear SP:FULL
can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller's (low pass
filter, phase) built-in
S.W Control:INT
auxiliary
S.W Control:EXT
Notes
• Even if you change this setting, there is no
output unless you switch the non fading out-
put (refer to page 60) or subwoofer output
(refer to page 59) in the audio menu on.
• If you change the subwoofer controller, sub-
woofer output and non fading output in the
audio menu return to the factory settings.
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting mode.
.
15
Rear
) connec-
Rear SP:S.W
Rear
).
is selected), you
or the
.
En
Section
10
73