Switching The Auxiliary Setting; Switching The Dimmer Setting; Adjusting The Brightness; Setting The Rear Output And Subwoofer Controller - Pioneer DEH-P7700MP Operation Manual

Initial Settings
2 Press Multi-Control to turn warning
tone on.
ON appears in the display.
# To turn warning tone off, press Multi-Control
again.

Switching the auxiliary setting

It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Use Multi-Control to select AUX.
AUX appears in the display.
2 Press Multi-Control to turn AUX on.
ON appears in the display.
# To turn AUX off, press Multi-Control again.

Switching the dimmer setting

To prevent the display from being too bright at
night, the display is automatically dimmed
when the cars headlights are turned on. You
can turn the dimmer on or off.
1 Use Multi-Control to select Dimmer.
Dimmer appears in the display.
2 Press Multi-Control to turn dimmer on.
ON appears in the display.
# To turn dimmer off, press Multi-Control
again.

Adjusting the brightness

You can adjust the display brightness. Initially
this mode is set to 12.
1 Use Multi-Control to select Brightness.
Brightness appears in the display.
2 Push Multi-Control left or right to ad-
just the brightness level.
Each pushing Multi-Control left or right in
creases or decreases the brightness level. 0 
15 is displayed as the level is increased or
decreased.
Setting the rear output and
subwoofer controller
This units rear output (rear speaker leads out
put and RCA rear output) can be used for full
range speaker (Rear SP :FULL) or subwoofer
(Rear SP :S/W) connection. If you switch the
rear output setting to the Rear SP :S/W, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full range speak
er connection (Rear SP :FULL). When rear out
put is connected to full range speakers (when
Rear SP :FULL is selected), you can connect
the RCA subwoofer output to a subwoofer. In
this case, you can select whether to use the
subwoofer controllers (low pass filter, phase)
built in Preout :S/W or the auxiliary
Preout :FULL.
1 Use Multi-Control to select SW control.
SW control appears in the display.
2 Press Multi-Control to switch the rear
output setting.
Pressing Multi-Control will switch between
Rear SP :FULL (full range speaker) and
Rear SP :S/W (subwoofer) and that status will
be displayed.
# When no subwoofer is connected to the rear
output, select Rear SP :FULL.
# When a subwoofer is connected to the rear
output, set for subwoofer Rear SP :S/W.
Section
12
55
En