Connect Vent - Kenmore W10850306A Installation Instructions Manual

5.
Attach long hose to dryer fi ll valve
and tighten coupling
Attach other end of long hose to fi ll
valve at top of dryer back panel.
Screw on coupling by hand until
it is seated on fi ll valve connector.
Using pliers, tighten the coupling an
additional two-thirds turn.
NOTE: Do not overtighten. Damage
to the coupling can result.
6.
Turn on cold water faucet
Check that the water faucet is turned on.
7.
Check for leaks
Check for leaks around "Y" connector, faucets, and hoses.
20
30 / "
1
4
(768 mm)
4"
(101 mm)

CONNECT VENT

1.
Connect vent to exhaust outlet
Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure vent is clean.
Vent must fi t over dryer exhaust outlet and inside exhaust
hood. Check that vent is secured to exhaust hood with a
4" (102 mm) clamp.
2.
Move dryer to fi nal location
Move dryer to fi nal location. Avoid crushing or kinking vent.