Connect Vent; Level Dryer - Kenmore 11075202310 Installation Instructions Manual

CONNECT VENT
1. Connect vent to exhaust outlet
Using a 4" (102 mm) clamp, connect vent to exhaust outlet in dryer.
Jf connecting to existing vent, make sure vent is clean. Dryer vent must
fit over dryer exhaust outlet and exhaust hood. Check that vent is
secured to exhaust hood with a 4" (102 mm) clamp.
2. Move dryer to flnal location
Move dryer to final location. Avoid crushing or kinking vent. After
dryer is in place, remove cardboard from under the dryer.
LEVEL DRYER
fi, Level dryer
Place level here
Place level here
f_
Check levelness of dryer from side to side. Repeat from front to back.
NOTE: The dryer must be level for the moisture sensing system to
operate correctly.
Not Level LEVEL Nat Level
2. Adjust leveling legs
If dryer is not level or the same height as the washer, prop up using a
wood block. Use wrench to adjust legs up or down, and check again
for levelness. Once legs are level, make sure all four legs are snug
against the floor before tightening them.
14