Siemens SIMATIC ET 200SP Manual page 26

Technical specifications
Article number
● up to 60 °C, max.
● up to 70 °C, max.
24 V encoder supply
● 24 V
● Short-circuit protection
Power
Power available from the backplane bus
Power loss
Power loss, typ.
Address area
Address space per module
● Address space per module, max.
Hardware configuration
Automatic encoding
● Mechanical coding element
Digital inputs
Number of digital inputs
Digital inputs, parameterizable
Source/sink input
Input characteristic curve in accordance with
IEC 61131, type 1
Input characteristic curve in accordance with
IEC 61131, type 2
Input characteristic curve in accordance with
IEC 61131, type 3
Pulse extension
● Length
Time stamping
Time stamp (with precision of 1 ms)
Edge evaluation
Input voltage
● Type of input voltage
● Rated value (DC)
● for signal "0"
● for signal "1"
Input current
● for signal "1", typ.
26
6DL1131-6BH00-0PH1
2 A; 1 A when mounted vertically; see derating
information in Equipment Manual
1 A; See derating information in Equipment Manual
Yes
Yes; Electronic (response threshold 0.7 A to 1.3
A; for IO redundancy up to 2.6 A) Ensure sufficient
low-resistance cable routing to the sensor/actuator
in order to attain the response threshold. Depend‐
ing on the cable cross-section used, there may be
constraints regarding the usable length of cable.
80 mW
3.6 W; Maximum value (taking the max. encoder
current and the max. operating voltage into ac‐
count)
2 byte; + 2 bytes for QI information (additional 18
bytes when using high-precision time stamping)
Yes
16
Yes
Yes; P-reading
Yes
No
Yes
Yes
Off, 50 ms, 100 ms, 200 ms, 500 ms, 1 s, 2 s
Yes; Resolution 10 ms
Yes; Resolution 1ms
Yes; rising edge, falling edge, edge change
DC
24 V
-30 to +5V
+11 to +30V
2.5 mA
Digital Input Module DI 16x24VDC HA (6DL1131-6BH00-0PH1)
Manual, 05/2017, A5E39265608-AA