Troubleshooting - Freemotion SFTL15619.2 User Manual

TROUBLESHOOTING
Most incline trainer problems can be solved by fol-
lowing the simple steps below. Find the symptom
that applies, and follow the steps listed, if further
assistance is needed, see the front cover of this
manual.
SYMPTOM: The power does not turn on
a.
Make sure that the power cord is plugged into a
surge suppressor and that the surge suppressor
is plugged into a properly grounded outlet (see
page 13). Use only a surge suppressor that meets
all of the specifications described on page 13.
IMPORTANT." The incline trainer is not compat=
ible with GFCl=equipped outlets and may not be
compatible with AFCl=equipped outlets.
b. After the power cord has been plugged in, make
sure that the key is inserted into the console.
C.
Check the power switch located on the incline
trainer frame near the power cord. If the switch
protrudes as shown, the switch has tripped. To
reset the power switch, wait for five minutes and
then press the switch back in.
Tripped
Reset
SYMPTOM: The power turns off during use
a. Check the power switch (see the drawing above).
If the switch has tripped, wait for five minutes and
then press the switch back in.
b. Make sure that the power cord is plugged in. If the
power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in.
c. Remove the key from the console, and then
reinsert it.
d. If the incline trainer still will not run, please see the
front cover of this manual.
SYMPTOM: The console displays remain lit when
you remove the key from the console
a.
The console features a display demo mode,
designed to be used if the incline trainer is dis-
played in a store. If the displays remain lit when
you remove the key, the demo mode is turned on.
To turn off the demo mode, hold down the Stop
button for a few seconds. If the displays are still
lit, see THE INFORMATION MODE on page 19 to
turn off the demo mode.
SYMPTOM: The displays of the console do not
function properly
a.
Remove the key from the console and UNPLUG
THE POWER CORD. Next, remove the three indi-
cated #8 x 1/2" Cover Screws (18). Lift off the Left
Roller Cover (38).
a
38
18
22