Hard Drive - HP Classmate Maintenance And Service Manual

Hard drive

Description
320-GB, 5400-rpm, 7 mm hard drive
Hard Drive Hardware Kit (includes hard drive bracket, rubber rails, sponge, and screws)
Hard drive connector cable
Before removing the hard drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board.
To remove a hard drive:
1. Remove the 4 Phillips PM2.0×3.0 screws (1) that secure the hard drive to the chassis.
2. Remove the Mylar tape from atop the system board connector (2).
3. Disconnect the cable from the system board connector (3).
Bottom cover on page 22).
Spare part number
786030-001
764408-001
764409-001
Component replacement procedures 37