Changing Batteries - Kärcher 1.013-100.0 Operating Instructions Manual

FOR SAFETY: Before leaving or servicing the
machine; stop on level surface and turn off
machine.

Changing Batteries

1. Open the control panel.
2. Disconnect battery pack from machine.
3. Use the proper size open end wrench to discon-
nect main ground wire first and secure cable
terminal away from batteries.
4. Disconnect main positive lead and secure cable
terminals away from batteries.
5. Remove bolt from Battery Strap.
6. Loosen both terminals on each jumper cable and
remove one at a time.
7. Prepare a suitable site to place the batteries.
Delta Q IC650 Charger Maintenance
Instructions
1. Do not expose charger to oil, dirt, mud or direct
2. The enclosure of the charger meets IP66, making it
3. If the detachable input power supply cord set is
86405760 ECO! T11 Bp LINER
heavy water spray when cleaning the vehicle or
machine.
dust-tight and protected against powerful water
jets. The AC inlet connection itself, when mated, is
rated to IP20, which is not protected against water.
Protect the AC connection if used in wet or dusty
environments.
damaged, replace with a cord that is appropriate
for your region:
- North America: UL or CSA listed / approved
detachable cord at least 1.8m in length (≥ 6 feet), 3
conductor, 16AWG minimum and rated SJT; termi-
nated in a grounding type IEC 60320 C14 plug
rated 250V, 13A minimum.
- All other regions: Safety approved detachable
cord, 3 conductor, 1.5mm² minimum, rated appro-
priately for industrial use. The cord set must be
terminated on one end with a grounding type input
connector appropriate for use in the country of
destination and, on the other end, an output
grounding type IEC 60320 C14 plug.
Maintenance
27