Table of Contents
Advertisement
Selecting a Charge Profile
1. Disconnect AC input from the charger, or from the
wall outlet. Wait 30 seconds for the input relay to
open.
2. While reconnecting AC input, press and hold
Select Charge Profile button. Hold the button until
Error Indicator is on and Battery Charging Indicator
starts flashing.
3. Press and release the Select charger Profile
Button to advance through charging profiles loaded
on the charger. The selected charging profile will
be displayed up to three times (e.g. "P-0-1-1" for
Profile 11).*
*Process will time out and profile will remain
unchanged if there is 15 seconds of inactivity, a profile
number is allowed to display three times, or if AC power
is cycled.
4. Once desired charging profile is displayed, press
5. Press the Select Charge Profile Button to check
Figure 1:
Disconnect AC
input from the
Use this table to record the charging profiles on
your charger.
charger.
Figure 2:
Reconnect AC
input while
holding the
Select Charge
Profile Button.
Figure 3:
Press the
Select Charge
Profile Logic
Profile Button
to advance
Profiles #42, 62 and 73 are programmed to automati-
through the
cally restart a charge cycle after 14 days or 1.8V/cell
charge
have been reached by the batteries if the charger
profiles. Hold
remains connected to AC power.
the button for
NOTE: Each profile is programmed to optimize the
10 seconds to
life and performance of their corresponding battery,
confirm your
contact the manufacturer before changing battery
selection.
charger profiles.
86405760 ECO! T11 Bp LINER
and hold button for 10 seconds (see Figure 3) to
confirm selection and exit Profile Selection Mode.
that the desired profile is selected.
Maintenance
29
Advertisement
Table of Contents
