Annually Or Every 1,000 Hours Reverse Exact-Track Bed; Replace Treadbelt; Maintenance Procedures Belt/Deck Lubrication - biodex 950-401 Application/Operation Manual

and timely application of the lubricant will prevent premature failures due to excessive wear
and load. Items affected by inadequate lubrication are the treadbelt, slider deck, motor, and
motor controller.

Annually or Every 1,000 Hours Reverse Exact-Track Bed

Reverse the Exact-Track bed. The Gait Trainer 3 bed is double-sided, allowing it to be reversed
and used over. Once both sides have been used, the bed must be replaced.

Replace Treadbelt

Inspect Treadbelt for cracks or tears. If none are found, continue to use. If any cracks or tears
are apparent, replace the treadbelt.

Maintenance Procedures Belt/Deck Lubrication

1. Using the large syringe provided, squirt one-half tube of the lubricant underneath the
center of the treadbelt (see Figure 10.4).
2. Walk ten steps on the Gait Trainer 3 at a speed of 1.0 mph. This will moisten an 8-inch
track underneath the center of the entire treadbelt.
3. Allow the Gait Trainer 3 to dry for approximately ten minutes.
NOTE: Use only the Biodex lubricant kit with the Gait Trainer 3. Most standard greases, waxes
and silicon sprays will build up on the rollers causing belt slippage and affecting tracking.
To re-order lubricant kit, use Biodex part # 945-276. Each container provides 12 applications.
GAIT TRAINER 3 (v3.X SOFTWARE) 91