Omron POWLI Instruction Manual page 84

l Function switching settings of the backup power supply stop signal
By setting the jumper on the printed circuit board of the SC08G (jumper symbol: JP5), switch the stop
signal function as follows:
Jumper
Jumper
setting
symbol
(Factory setting)
JP5 BS side
l High signal input voltage range settings of the backup power supply stop signal
By setting the jumper on the printed circuit board of the SC08G (jumper symbol: JP7), set the input volt-
age range on the High side of the backup power supply stop signal as follows:
Jumper
Jumper
setting
symbol
(Factory setting)
24 VDC
JP7
side
Do not apply voltage higher than the set High signal input voltage range.
● Doing so may cause failure or damage of the card unit, resulting in a fire or electric shock.
l UPS Start/Stop setting of the remote ON/OFF signal
By setting the jumper on the printed circuit board of the SC08G (jumper symbol: JP7), set the UPS Start/
Stop by the remote ON/OFF signal as follows:
Jumper
Jumper
setting
symbol
(Factory setting)
OP-OFF
JP6
side
Function
The UPS stops upon receiving the
High signal input.
Function
High signal input voltage range
from 8V to 24 V
Function
External contact open UPS stop
External contact close UPS start
1002
BU
Jumper
setting
The UPS stops upon receiving the
BS side
Low signal input.
Jumper
setting
12 VDC High signal input voltage range from
side 5V to 12 V
Caution
Jumper
setting
External contact open
CL-OFF
side
External contact close
3002
SWG / BU SWG
Jumper setting
Jumper setting
Jumper setting
UPS start
UPS stop
7
71