Table of Contents
Advertisement
iCanView220/220W User's Guide
Connector for connecting 3dBi antenna supplied with I CanView220/220W. Antenna connector
is located at inside of the network camera.
2.4. PC Requirements
AV streaming data received from iCanView220/220W can be decoded or stored in a PC running i-
NVR program which is a viewing & recording program for a PC. Minimum requirement of the PC is
described below:
CPU
Main Memory
*
Operating system
Web browser
Resolution
Network
* Operating Systems supported : Windows 2000 Professional
2.5 Quick Installation Guide
Brief information for rapid installation is provided in this section. For more detailed information you
are recommended to refer to pertinent documentations provided with the product or refer to
iCanTek's home page (http://www.icantek.com)
1.
Connect iCanView220/220W to LAN by using one of the following methods
1) If you have power adaptor and PoE injector, connect the network camera and PC as
illustrated in Figure 2.5. Both power and network connection is made with a single LAN
cable.
2) If you have power adaptor with PoE, connect the network camera and PC as illustrated in
Figure 2.6. Both power and network connection is made with a single LAN cable.
The propriety PoE (Power over Ethernet) adds convenience in installing the network
Minimum
Pentium III 700
128 MB
Windows 2000 or later
Internet Explorer 5.0
1,024 X 768
10 Base-T Ethernet
Windows XP Professional / Windows XP Home Edition
Recommended
Pentium IV 1.2G above
256MB above
Windows 2000 or later
Internet Explorer 5.0 above
Higher than 1,024 X 768
100 Base-T Ethernet
Rev.1.0 (Aug. 2006)
Advertisement
Table of Contents
