E3 Motor 2 Set-Up - YASKAWA VS-616G5 Series Programming Manual

E3 Motor 2 Set-up
E3-01 Motor 2 Control Method Selection
The G5 inverter has the capability to control 2 motors independently. A second motor may be selected
using a multi-function contact input.
Select the control method best suited for your application for Motor 2.
Setting
0
1
2
3
The following is a list of parameters that become effective when motor 2 is selected.
Function E3
Control Method 2
E3-01 Control Method 2 E4-01
The inverter must be stopped to switch motors.
VS-616G5 Programming Manual
V/f Control - For general-purpose and multiple motor applications.
V/f with PG Feedback - For general-purpose applications requiring closed
loop speed control.
Open Loop Vector (factory default) - For applications requiring precise
speed control, quick response and higher torque at low speeds (150%
torque below 1Hz).
Flux Vector - For applications requiring very precise speed and torque con-
trol at a wide speed range including 0 speed. Uses encoder feedback.
G5
Function E4
V/F Pattern 2
E4-02
E4-03
E4-04
E4-05
E4-06
E4-07
Control Method
Description
M
M
Max Frequency E5-01
Max Voltage E5-02
Base Frequency E5-03
Mid Frequency E5-05
Mid Voltage E5-06
Min Frequency
Min Voltage
Section E: Motor Parameters

E3 Motor 2 Set-up

Open Loop Flux
V/f V/f w/PG
Vector Vector
A A A
Motor 1
Motor 2
Function E5
Motor Setup 2
Motor Rated FLA
Motor Rated Slip
No-Load Current
Term Resistance
Leak Inductance
A
61