O2 Key Selection - YASKAWA VS-616G5 Series Programming Manual

Section L: Operator Parameters
O2 Key Selections
O1-04 Display Units for Speed-Related Parameters
Sets the display units for parameters and monitors related to frequency, in the flux vector control mode.
O1-05 Parameter Selection
Selects how the parameter addresses are displayed on the digital operator.
O2 Key Selections
O2-01 Local/Remote Key
Enables/disables the digital operator LOCAL/REMOTE key.
Setting
O2-02 STOP Key During External Terminal Operation
Enables/disables the digital operator STOP key, during operation from the external terminals and dur-
ing serial communication.
Setting
0
1
122
Setting
0
Displays frequency in Hz (factory default).
1 Displays frequency in rpm.
Setting
0 Displays parameter number (factory default).
1 Displays MODBUS address.
0 Local/Remote key is disabled.
1 Local/Remote key is enabled (factory default).
Depressing the Local/Remote key switches operation commands
between the digital operator and the settings of B1-01 and B1-02.
The digital operator STOP key is disabled when Run command does not come from the dig-
ital operator.
The digital operator STOP key is always enabled (factory default).
The STOP key is enabled even during external terminal operation and serial communication.
Display Units
Description
Address Display
Description
Local/Remote Key
Description
Oper STOP Key
Description
VS-616G5 Programming Manual
− − −
B
A A A A
B B B B
B B B B