Troubleshooting - Protocol neo-drone AP Instruction Manual

TROUBLESHOOTING

*Allow 15 minutes to pass between full flights as this will give the motors a chance
to cool down. Failure to do so could wear out and shorten the life
of the motors.
SYMPTOM
Neo-Drone AP
does not
respond
Response to
control inputs
intermittent
or erratic
Neo-Drone AP
will not hover
or strafe
correctly
HOW TO CHANGE THE BLADES
- All drones have two rotors that spin clockwise and two rotors that spin
counter-clockwise.
- Make sure to place the blades on the correct axis or they will not spin
correctly and the drone will not lift.
- Each blade is marked on its underside with A or B. There may be a number
after the letter but you can ignore the number.
- Make sure to follow the graphic below to see where to place the blades.
BLADES A
BLADES B
POSSIBLE CAUSE
1. Communication between
controller and aircraft was not
synchronized during set up
2. Battery power depleted on
aircraft, controller or both.
1. Controller battery power
nearly depleted.
1. The aircraft was not
on level ground during
synchronization.
2. Trim settings are incorrect.
MAIN
MAIN
POTENTIAL SOLUTION
1. To synchronize, turn on aircraft,
place it on the ground, and then
turn on the remote.
2. Charge aircraft and/or replace
batteries in controller.
1. Replace batteries in controller.
1. Re-synchronize aircraft
and controller.
2. Reset the trim buttons on the
controller and re-trim flight controls.
FRONT
OF
DRONE
MAIN
BLADES B
MAIN
BLADES A
13