Global Stndby; Calibrate Jcu; Cancel; Factory Default Settings - FLIR M-SERIES Operator's Manual

M-Series System Startup

Global Stndby?

When Global Stndby? is selected, all discovered cameras and JCUs found on the network are
placed in standby. This function is used to properly shut down all cameras (return to stow position)
and JCUs prior to removing power with the system breaker.
Note: Global Stndby? displays as an option only when multiple JCUs or cameras are found
on the network.

Calibrate JCU

Calibrate JCU is used to standardize the movements of the JCU puck. This function might be
used, for example, if the camera responds at a different rate when the puck is pushed left rather
than right, or when the puck is twisted in one direction compared to the other. The JCU display
directs the user to move and twist the puck in certain ways so the device can be calibrated.
After entering calibration mode, you will be instructed to move the puck to the maximum extent
possible in each direction separately. After that has been done, pressing the puck moves to the
next step. For example, Rotate CW/CCW requires rotating the puck clockwise to the full extent
possible, and then rotating counter clockwise to the full extent possible. When both directions are
completed, press the puck to continue.

Cancel

The Cancel option causes the JCU to exit the Power Menu and return to its normal state.

Factory Default Settings

Table 3.1 shows the factory default settings for the M-Series configuration options and the JCU
buttons. M-Series System Configuration, pg. 24
Factory Default Settings
TABLE 3.1
Option
Aircraft Joystick
Ball-Down Installation
Camera Name
Color Thermal Video
High Motor Torque
High Power Standby
Home Position
Icon Display Mode
Network Configuration
Vertical Stab Only
Rearview Mode
Scan Width
Scan Speed
432-0003-60-10 Version 100
describes how to modify and update settings.
Factory Default Setting
Disabled
Disabled (not available on M-618CS model cameras)
Model number followed by serial number (for example,
M-617CS JD-0123)
Enabled
Enabled
Enabled
o o
0 azimuth, 0 elevation
Display Minimal
Dynamic
Disabled
Disabled
Wide
Slow
May 2017 22