Table of Contents
Advertisement
Safety notices
12
NOTE:
Occasionally, persons using the tanning device will experi-
ence a slight reddening of the skin – usually in small patches
– after the second or third session. This redness is often
accompanied by an itching sensation. This may be nothing
more than a very limited heat 'rash' caused by heat from the
lamps within the device and it should go away within ap-
proximately 24 hours and not reappear. This rash can be
lessened or prevented by applying moisturizing lotion to the
affected area after the tanning session is completed.
•
Follow instructions.
•
The time between the first two tanning sessions must be
at least 24 hours.
•
Increasing tanning also requires an extension of the
exposure time (= radiation time). After a certain degree
of tanning has been achieved a further intensification is
not possible. The session time may not be extended to
exceed the scope of the permissible radiation doses!
Only a certain degree of tanning, dependent on the skin
type, can be achieved without endangering your health.
•
Inform users about proper tanning.
Behavior before, during and after the application:
No other persons are permitted in the vicinity of the cabin when using the
device, this especially applies to children.
Remove all jewelry (including piercings) prior to the application.
Remove cosmetics before using the device and do not use sun screen
products.
3.2.2
Sensor
The sensor may not be used on the following parts of the body:
Moles, liver spots and veins
Wounds, scars and pimples
Reddened areas (rosacea, sunburn)
Tattoos
Hairy skin
Heavy wrinkles
Skin covered by / treated with make-up, cosmetics, self-tanning lotions
Sweaty, damp or shiny skin
Avoid incorrect usage, e.g.:
Placing the sensor at an angle
Pressing too strongly when measuring (alters the blood flow to the skin in
the area measured)
Advertisement
Table of Contents
