Cisco IE 4010 Hardware Installation Manual page 62

Configuring the Switch with the CLI Setup Program
Accessing the CLI Through Express Setup
— You can add a serial console cable to monitor the booting sequence. Do not hit [return key] on console screen.
— Ensure the computer connected to switch is configured with DHCP.
4. Web Browser: disable pop-up blockers and proxy settings.
5. Connect power to the switch.
See the wiring instructions in
6. Power on or reset the switch.
Use LEDs to monitor boot progress:
— Sys blinking: bootloader
— Sysl Blank: POST
— Sys solid: exit post, IOS initializing
— Sys and alarm LEDs green: IOS init done
— ~90 – 100 seconds after power on
— EXP blinking: ready for express setup process
7. Insert paper clip into express setup button (see
When released, port Gig1/1 LED starts flashing green.
8. Connect computer to port Gig1/1.
LED continues to blink.
9. After computer has IP address (169.254.0.2), point browser to http://169.254.0.1.
10. Leave the username blank and enter the default password, cisco.
Note: The switch ignores text in the username field. The Express Setup window appears.
Troubleshooting: If the Express Setup window does not appear, make sure that any pop-up blockers or proxy
settings on your browser are disabled and that any wireless client is disabled on your computer.
Note: The screen capture below shows an IE 4000 series switch, but the functionality is identical for the IE 4010.
Grounding the Switch, page 36
Figure 4 on page
58
and Wiring the Power Source, page
6) for 1-2 seconds.
39.