Cisco IE 4010 Hardware Installation Manual page 37

Power Supply Installation
This chapter describes how to remove and install a new or replacement power supply. Your switch ships with at least
one installed power-supply module (AC or DC, depending on your order).
The power-supply modules are field-replaceable units (FRUs) and are hot-swappable when deployed in non-hazardous
locations.
For translations of the safety warnings in this chapter, see the Regulatory Compliance and Safety Information for the
Cisco IE 4010 Switch on Cisco.com.

Power-Supply Modules, page 34

Installation Guidelines, page 35

Grounding the Switch, page 36

Installing the Power-Supply Module in the Switch, page 37

Wiring the Power Source, page 39

Removing the Power-Supply Module, page 44
Cisco Systems, Inc. www.cisco.com
33