Table of Contents
Advertisement
Chapter 1 Maintenance
6.1.2
Starting by the management terminal
This section describes how to start the system diagnostic management tool by the management terminal.
When you start it by the management terminal, you can diagnose all server modules by the system diagnostic
management tool. Note that terminals to be prepared are restricted. Therefore, the system diagnostic
management tool may not properly operate even if it meets conditions.
See "Chapter 1 (6.1.1 Starting in the server)" to start the system diagnostic management tool in this server.
(1)
Preparation
The following preparation is required to execute the system diagnostic management tool.
Do not connect the LAN cable (see <5>) until you are instructed by the starting procedure.
Rear side
Front side
<1>Management terminal
The terminal supports Linux and needs to be equipped with the following devices.
1) LAN port (Intel, Broadcom and Realtek supported)
Connect LAN to the management LAN connector of the network NW switch module #1 of this server.
Make it connectable to NW switch module #1 and #2 via a network hub if the BMC setting of the server
module is set to duplication enabled.
2) USB port
3) CD/DVD-ROM drive
<5>
USB
Connection image
Scalable Modular Server DX2000 Maintenance Guide
<1>
<2>
NW switch module#1
NW switch module#2
6. System Diagnostic Tool
<3>
<4>
31
Advertisement
Table of Contents
